Water Based Epoxy Enamel Base Pack 5.5Kg.
SKU:Base P and TR(white and transparent) for the preparation of two-component waterborne epoxy enamel paint colors by the EUROTEX-SYSTEM tintometric system, for the painting of interior floors requiring high mechanical and chemical resistance.
- Colors Range of colors available under tintometric system
- Recommended coverage: 500 g/m2 applied in two coats.
- Dry to touch: 1-2 hours
Description
Base for the preparation of Waterborne Epoxy Enamel colors.
Main uses:
- Stores
- Institutional centers
- Clinics, health centers
- Parking
- Workshops - ITV
- Graphic arts,
- Warehouses
- Logistics areas
- Distribution centers
- Industrial buildings
- Food industry
- Textile industry
Computer industry - Electronics industry
- Mechanical industry
- Chemical industry
- Pharmaceutical industry
- Light industry
Application data:
- Yield for a single coat: 250 g/m2
- Pot life (Pot life): 35 minutes
- Recoating time: between 12 and 48 hours
- Solvent for cleaning: Solvent type MPA / Synthetic / Water
- Dilution: Water 0 - 10 %.
Instructions for use
The product is presented in pre-dosed batches, respecting the mixing ratio as much as possible and taking special care to drag the remains adhered to the bottom and walls of the container. The mixing operation of the components is carried out mechanically until a homogeneous mixture is obtained, using a low speed mixer (600 rpm) equipped with propellers that do not favor the entry of air and the formation of bubbles. First beat each of the components separately and then pour the component from the small container or component B into the large container or component A, beating the mixture until it is completely homogenized (approximately 1-2 minutes). While whisking the mixture, add water slowly as a diluent until the proper viscosity for the application is achieved(Do not add more than 10 % water). It should be taken into account that the pot-life of the mixture depends on the temperature(the higher the temperature, the lower the pot-life and vice versa). Apply with a roller, ensuring the formation of a continuous layer without pores.
