Anti-Slip Floor Additive
SKU:This additive is specially designed to be added to enamels, paints or varnishes that require a non-slip finish.
Description
In paints, resins and varnishes, it creates anti-slip coatings.
The anti-slip additive is used to provide adhesion to all types of products, from epoxy resins, polyurethane, resins for printed concrete, both water and solvent-based, plastic paints and chlorinated rubber. This anti-slip is caused because the additive remains in the film and the surface is therefore roughened.
In products that deposit little layer and film, it is recommended to apply an additional coat of coating so that the additive does not skip.
It is applied mixed with the resins/paints (if it is bicomponent with component A) at a minimum percentage of 5%, being able to increase the quantity added according to the required anti-slip/abrasive capacities.
Below, we show an example of the Anti-Slip Additive mixed, at 5%, with our Single-Component Transparent Polyurethane Membrane on a non-porous tile. The application has been made on half of the tile so that the contrast of the final finish against the natural state of the surface can be appreciated.
