Protective Coating - Ocean F3 Myto AMH
SKU:Smooth coating used in the decoration and protection of vertical and horizontal surfaces, both interior and exterior, executed with common construction materials(concrete, cement, brick, fiber cement or plasterboard). Océano F3 Myto is based on an aqueous dispersion of specially selected acrylic copolymers that give it good resistance to difficult weather conditions, good whiteness and covering power, thus achieving a good quality waterproof finish.
- Contains state-of-the-art additives that protect the film against molds and mildew
- 5 years warranty
- Washability (Class 2)
- BS1D0 Reaction to Fire Certificate
- Impermeable to rainwater and permeable to air and water vapor
- Good weather resistance
- Good erosion resistance
- Very good friction resistance
Description
Technical specifications of this protective coating
- Binder Acrylic copolymers
- Diluent Water
- Color White
- Matte Gloss
- Drying times: Drying to touch: 1 - 2 hours at 20º C
- Recoating interval Minimum: 6 - 12 hours at 20º C. Maximum: None.
*Technical specifications may vary depending on substrate, humidity or temperature.
Main applications
The application can be done with brush, roller or spray gun, after shaking the product and dilution. The cleaning of equipment should be done with water before the paint dries. Once dry, it is necessary to use cleaning solvent.
- Exterior use: Apply on facades, walls, exterior walls and light courtyards.
- Indoor use: All types of interior walls and ceilings, on common construction materials (on plaster, cement, mortar or plasterboard).
Instructions for use of Ocean F3 Myto
- Treatment of the support:
The substrate must be clean, dry, free of grease or contaminants, free of loose elements and free of areas affected by biodegradation areas affected by biodegradation that prevent the correct anchorage or affect the durability of the painting system. durability of the painting system.
New concrete surfaces: Allow concrete to set completely (28 days minimum). Remove set slurry, soluble salts, dust, grease, oil and other contaminants soluble salts, dust, grease, oil and other contaminants by mechanical or manual procedures. manual procedures.
Surfaces already painted of concrete or fiber cement: Remove dust and disintegrable materials by mechanical or manual procedures. mechanical or manual procedures. The painted surfaces in bad condition, must be completely eliminated using high pressure water completely using high pressure water machinery. Do not use chemical products of acid or alkaline nature alkaline in the cleaning works, since they could damage irreversibly to the base support.
On other types of substrates: The solidity and anchorage of the paint must be previously checked, as well as the nature of the substrate in order to avoid possible incompatibilities. diagnose the nature of the support in order to avoid possible incompatibilities. Eurotex cannot Eurotex cannot guarantee the performance of the paint on other products.
- Product application:
Primer: Apply a coat of Eurofijador Eurotex (WATER-BASED) diluted one part per 4 of water if the surface is firm, dry, absorbent and compact. firm, dry, absorbent and compact, or EUROTEX HYDROFIX EUROTEX SEALER (SOLVENT) diluted 25 to 75% of Eurosolv-X if the surface has a lack of consistency. diluted with 25 to 75% of Eurosolv-X if the surface has a lack of consistency and high absorption.
Finishing: Apply a first coat of Océano F3 Myto, diluted between 5 - 10 % with water. Allow to dry between coats coats for 6 - 12 hours depending on application conditions. Then apply one or two finishing coats (depending on the characteristics of the support) with a maximum dilution of 5% with water.
