Europoxy Primer Metal E1261 Aluminum
SKU: 45646A two-component, pigmented, thick film polyamide epoxy paint with high solids aluminum flakes. Especially recommended as a primer, intermediate or finishing coat for epoxy systems in highly corrosive environments such as industrial or marine. It has good adhesion on surfaces with little preparation and on a wide variety of aged paints. Complies with the requirements of the UNE 48261 standard.
Certified according to UNE 48261: 2003 standards according to report number 08152 dated September 19, 2010 issued by OTEC-RIERA. Complies with the requirements of the thermal resistance test at 105º C in dry conditions according to report number 08153 dated September 4, 2010. according to report number 08153 dated September 4, 2010.
Description
TECHNICAL SPECIFICATIONS
-
- Polyamide epoxy binder
- Color / Finish Aluminum / Satin
- Solids by volume 80 +/-2 %.
- Density at 20º C (U.N.E. 48098) Comp A: 1.15 +/- 0.03 Kg/L
- Comp B: 1.15 +/- 0.05 Kg/L
- Viscosity of the mixture at 20º (U.N.E. 48076) Comp A: 125 +/- 5 ku
- Comp B: 115 +/- 5 ku
- VOC 165 - 175 gr./liter
- Flash point > 24° C
- Maximum operating temperature 100º C
*Technical specifications may vary depending on the substrate, humidity or temperature.
APPLICATION DATA
- Dilution / Cleaning Epoxy solvent 5 - 10 %.
- Mixing ratio 1:1 Volume
- Theoretical Coverage 5.3 m2 / L at 150 microns dry.
- Recommended thickness Wet: 200 - 225 micron Dry: 150 - 175 micron
- Mixed life
- 5º C - 6 Hours
- 20º C - 4 Hours
- 30º C - 2 Hours
- Airless spray gun application
- Boq pressure: 180 - 250 bar.
- Boq diameter: 0.48 - 0.66 mm.
- Compression ratio: 50 : 1
- Application angle: 40 - 80 degrees.
- Dilution: 0 - 5 % in volume.
- Brush / Roller Dilution: 10 % by volume.
RECOMMENDED PAINT SCHEME
Primer: Barnipox 200 - 1 x 50 micron dry film thickness.
Intermediate Coat: Europoxy metal primer E1261 ALU - 1 x 150 micron dry film thickness.
Finish: Apply two coats of Barnicoat, Imperthane PUR or according to specification.
