Ocean F20 - Pliolite Coating
SKU:Solvent-based facade coating with high adhesion, opacity and penetration power on degraded substrates. Provides excellent weather resistance, high hardness and breathability. Totally resistant to alkalis, waterproof and totally breathable.
- 10 years warranty* 10 years warranty* 10 years warranty* 10 years warranty
- Rainwater resistant paint
- Color Matte White
- Suitable both outdoors and indoors
- Theoretical yield 6-8 m2/L
Description
Ocean F20 Pliolite has excellent resistance to rainwater.
Technical specifications
- Color White
- Matte Gloss
- Flash point 43° C
- Yield at 98% opacity 6-8 m²/L
- Drying times: Dry to touch: 1h at 20ºC.
- Recoat interval (UNE EN ISO 9117) Minimum: 24 hours. Maximum: Indefinite
* Technical specifications may vary depending on color, substrate, humidity or temperature.
Application data
- Recommended thickness Wet: 150 +/- 10 Dry: 75 +/- 10
- Airless" spray gun Dilution: 5% by volume
- Air spray gun Dilution: 10% by volume
- Brush / Roller Dilution: 10% by volume
- Thinner / cleaning Chlorinated rubber solvent
Surface preparation
- Before painting, the surface (cement, plaster, etc.) must be allowed to dry for a minimum of two weeks to ensure that the surface (cement, plaster, etc.) is completely cured.
- The surface must be dry, free of soluble salts before repainting. The best adhesion results are obtained when the previous coat is not completely cured.
- In prolonged exposure times it is recommended to give a slight surface roughness to favor the adhesion by mechanical anchorage of the following coats.
Instructions for use
Apply a first coat of paint by adding 10 + 5 % of chlorinated rubber thinner so that it penetrates deeply through the porosity of the surface. The second coat will be applied diluting as little as possible with an interval of 24 hours. The drying time before repainting could vary depending on the thickness of the film applied, ventilation, humidity, etc.
Application conditions
Apply with temperatures above 10º C and relative humidity below 75%. The temperature of the paint and the surface must be above this limit. Do not apply if rain is expected, with high humidity or with substrate temperatures at least 3º C above the dew point. The maximum recommended temperature at which the substrate should be approximately 30º C.
